Victron Quattro Inverter/Charger 5000 W

Description

Send to friend

Reviews

Two AC inputs with integrated transfer switch

The Quattro can be connected to two independent AC sources, for example shore-side power and a generator, or two generators. The Quattro will automatically connect to the active source.

Two AC Outputs

The main output has no-break functionality. In the event of a grid failure, or shore or generator power being disconnected, the Quattro takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption. The second output is live only when AC is available on one of the inputs of the Quattro. Loads that should not discharge the battery, such as air-conditioning or a water heater can be connected to this output.

Unique PowerAssist feature

The Quattro will prevent overload of a limited AC source. First, battery charging will automatically be reduced when otherwise an overload would occur. The second level will boost the output of a generator or shore side supply with power taken from the battery.

Virtually unlimited power thanks to parallel operation

Up to 6 Quattro’s can operate in parallel to achieve higher power output. Three phase or split phase operation is also possible.

Related products

	VE Interface MK.2B Phoenix Inverters are ready to communicate with a computer through its RS-485 data port. All you need to link to your PC in order to be able to set and read out all parameters is the data link as shown. Moreover, all Victron Energy products equipped with an RS-485 data port, such as VE.Net, can easily be integrated in a computerized monitoring and control system. Only for models: 12/1200, 12/1600, 12/3000, 12/5000, 24/1200, 24/1600, 24/3000, 24/5000, 48/3000, 48/5000 VE-Configure software and a RJ45 UTP cable required.
	Digital Multi Control 200/200A This panel is intended both for Multi's and Quattro's. It allows PowerControl and PowerAssist current limit setting for two AC sources: a generator and shore-side current for example. Fixed setting range (for both models): 200 Amps. The brightness of the LED's is automatically reduced during night time.
	Phoenix Multi Control This panel is intended both for Multi's and Quattro's. It allows PowerControl and PowerAssist current limit setting for two AC sources: a generator and shore-side current for example. Variable setting range (with the rotary knob): up to 16 Amps (VE.Bus Multi Control 16/200A panel) or up 30 Amps (VE.Bust Multi Control 30/200A panel). Fixed setting range (for both models): 200 Amps. The brightness of the LED's is automatically reduced during night time.
	Battery Alarm An excessively high or low battery voltage is indicated by an audible and visual alarm, and a relay for remote signalling.
	RJ45 UTP Cable Allows to connect Phoenix Inverter Control or VE Interface MK2b. 5M ASS030065000 10M ASS030065010 15M ASS030065020